I'm considering how to do the wiring for the new detection system. When this sensor X and this sensor Y are both turned on I want it to make the system stop, but how do you think I should wire it?
我在研究新檢測裝置的配線。我想在這里的X傳感器和Y傳感器同時為ON的時候讓裝置停止，該怎么配線呢？
Cindy
If that's what you are doing, a series wiring would work.
By the way, what is the purpose of putting in these sensors?
那樣的話，采用串聯配線就可以了。
你安裝這些傳感器的目的是什么呢？
王工
I'm putting them in to ensure safety. Is there anything else I should be careful of when I do the wiring?
是為了確保安全才安裝的。
在配線時，還有其它需要注意的地方嗎？
Cindy
If you are using them as a safety device, Normal Close should be used for the wiring so that a signal is sent when the sensor is off, not on. Otherwise, if the sensor is broken there is a chance that a signal might be sent from Normal Open and cause a safety problem.
如果是作為安全對策，就必須在傳感器為OFF而非ON時發出信號的B接點處進行配線。否則，如果使用A接點，那么在傳感器損壞時也會發出信號，引起安全問題。

返回目錄

湘乡市| 临朐县| 新宁县| 中西区| 墨江| 常宁市| 临夏县| 习水县| 金寨县| 濉溪县| 申扎县| 剑川县| 济宁市| 罗甸县| 格尔木市| 濉溪县| 乌拉特后旗| 梅河口市| 民勤县| 石楼县| 会东县| 甘德县| 仙居县| 武义县| 桐庐县| 杭州市| 双辽市| 义乌市| 大埔县| 庄河市| 长泰县| 诏安县| 龙海市| 永泰县| 虎林市| 且末县| 昌江| 霍城县| 潢川县| 九台市| 九龙县|